Beyond INF-B Manuale dell'Operatore Scaricare il pdf (Pagina 33)

WARNING: Do not “turn-on” the ac power and input signals until all connections are

connected to the meter.

11. Set P1, the AC power connector, aside and connect or reconnect all other connectors to the back

of the meter using Figure 4-3 in Section 4.2 as guides.

Connect P1 last.

The P1 connector is “keyed”; it is shaped in such a way that it fits only the J1 male pins.

12. Replace the rear protective cover and secure it with the cover mounting screw.

Your meter is now ready for operation and you can turn-on the power.

WARNING: The unit becomes active as soon as it is connected to a power source.

It has no On or Off switch. The unit at first momentarily shows the software

(or Firmware) version number, during this time, user can switch to older Configuration

Menu, “MENU 2” (the use of MENU 2 is not covered in this manual, refer to “Menu 2

Manual” for proper instructions), followed by “RESET 2”, and then proceeds to the

Run Mode.

Setup

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 131 132

Nessun commento

Beyond INF-B Manuale dell'Operatore Pagina 33